Техническая Инструкция для Cisco Cisco Identity Services Engine 1.0.4
ISE with Static Redirect for Isolated Guest
Networks Configuration Example
Networks Configuration Example
Document ID: 117620
Contributed by Jesse Dubois, Cisco TAC Engineer.
Apr 23, 2014
Apr 23, 2014
Contents
Introduction
Prerequisites
Requirements
Components Used
Background Information
Configure
Network Diagram
Configuration
Verify
Troubleshoot
Prerequisites
Requirements
Components Used
Background Information
Configure
Network Diagram
Configuration
Verify
Troubleshoot
Introduction
This document describes how to configure the Cisco Identity Services Engine (ISE) with static redirect for
isolated guest networks in order to maintain redundancy. It also describes how to configure the policy node so
that clients are not prompted with an unverifiable certificate warning.
isolated guest networks in order to maintain redundancy. It also describes how to configure the policy node so
that clients are not prompted with an unverifiable certificate warning.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Cisco ISE Central Web Authentication (CWA) and all related components
•
Browser verification of certificate validity
•
Cisco ISE Version 1.2.0.899 or later
•
Cisco Wireless LAN Controller (WLC) Version 7.2.110.0 or later (Version 7.4.100.0 or later is
preferred)
preferred)
•
Note: CWA is described in the Central Web Authentication on the WLC and ISE Configuration
Example Cisco article.
Example Cisco article.
Components Used
The information in this document is based on these software and hardware versions:
Cisco ISE Version 1.2.0.899
•
Cisco Virtual WLC (vWLC) Version 7.4.110.0
•
Cisco Adaptive Security Appliance (ASA) Version 8.2.5
•