Руководство По Устранению Ошибки для Cisco Cisco Identity Services Engine 1.0.4
Contents
Introduction
Prerequisites
Requirements
Components Used
Problem
Solution
Additional Issues
VMware Issues
Related Information
Introduction
This document describes a problem that is encountered when the Cisco Identity Services Engine
(ISE) and other Linux-based servers fail to synchronize with a Network Time Protocol (NTP)
server that is installed on a Microsoft Windows Server. A solution to this problem is also provided.
(ISE) and other Linux-based servers fail to synchronize with a Network Time Protocol (NTP)
server that is installed on a Microsoft Windows Server. A solution to this problem is also provided.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Cisco ISE CLI configuration
●
Basic knowledge about NTP
●
Components Used
The information in this document is based on these software and hardware versions:
Microsoft Windows Server Version 2012
●
Cisco ISE software Versions 1.3 and later
●
The information in this document was created from the devices in a specific lab environment. All of
the devices used in this document started with a cleared (default) configuration. If your network is
live, make sure that you understand the potential impact of any command.
the devices used in this document started with a cleared (default) configuration. If your network is
live, make sure that you understand the potential impact of any command.
Problem
After you configure the ISE CLI in order to use the Microsoft Windows Server as NTP, it does not
synchronize. The Microsoft Windows Server 2012 default domain controller configuration is used
(default NTP configuration). The ISE reports that the local source is still used:
synchronize. The Microsoft Windows Server 2012 default domain controller configuration is used
(default NTP configuration). The ISE reports that the local source is still used: