Техническая Спецификация для Cisco Cisco Aironet 1572EC Outdoor Access Point

Скачать
Страница из 17
 
 
© 2015 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. 
Page 8 of 17 
Power over Ethernet 
The AP1572EAC can be powered over the Ethernet connection. Power can be sourced directly from an 
appropriately powered Universal Power over Ethernet (UPoE) switch port or from the inline power injector listed in 
Table 12. 
Table 12. 
Power Injector for Use with PoE 
Part Number 
Description 
AIR-PWRINJ1500-2= 
1520/1550/1570 Series Power Injector; for indoor environments only 
You must also specify the country type AC power cord for the power injector. 
The Aironet 1570 Series access points use a standard RJ-45 Ethernet connector. Cisco does not provide an 
Ethernet cable for the 1570 Series. You will need to source an outdoor-rated, Category 5 or better Ethernet cable 
and shielded RJ-45 connectors from a local supplier. A liquid-tight gland is provided with the access point to seal 
this cable entry point from weather. 
DC Power 
The Aironet 1570 Series access points support power from an external DC power supply. Check the 
 for 
the associated voltage, current range, and power consumption. A DC terminal block is included with the 
AP1572EAC for this purpose. While not common, the cable-powered AP1572IC and AP1572EC can also use DC 
power. For that, an accessory kit is available to provide DC terminal block connectors (
). Note that these DC connectors are specifically for the Aironet 1570 Series and should not be 
interchanged with DC terminal blocks for the previous AP1520, AP1550, or 1530 models. When using DC power, 
please consult the 
 for instructions on how to correctly assemble the connector. 
SFP 
All the Cisco Aironet 1570 Series Outdoor Access Points support fiber backhaul. The SFP is built into the AP, but 
the mechanical interface is external to the AP. A special SFP adapter/gland kit is needed to interface the fiber 
cable to the AP. Table 13 lists the SFP and the adapter/gland accessory kit, and Figure 2 illustrates them. 
Table 13. 
SFP Components for use with AP1570 
Powering Option 
Description 
AIR-ACC15-SFP-GLD= 
Accessory, SFP external Gland/Adapter, bag of 5 units 
GLC-LX-SM-RGD= 
1000BASE-LX single-mode Rugged SFP 
GLC-SX-MM-RGD= 
1000BASE-SX multi-mode Rugged SFP