Руководство По Установке для Cisco Cisco MGX 8250 Edge Concentrator
Corporate Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706. USA
Copyright © 2000. Cisco Systems, Inc. All rights reserved.
78-10389-01
Installing Plastic Motherboard Insulator in an
MGX 8850 System
MGX 8850 System
Installing Backplane Plastic Insulating Cover
Use the following procedure to install the insulating cover over a system’s backplane. This procedure
may be done without powering down the system.
may be done without powering down the system.
Step 1
Open the plastic grill on the front side of the intake plenum, located directly underneath the card cage
or the fan space, using a flat blade screw driver to loosen the two recessed screws. Tilt the plastic grill
forward about 45 degrees, then lift out and set it aside.
or the fan space, using a flat blade screw driver to loosen the two recessed screws. Tilt the plastic grill
forward about 45 degrees, then lift out and set it aside.
Step 2
Hold the plastic cover, shown in the drawing below, so that the 16 short tabs are facing towards you.
43776
3 Tabs
Short tabs