Листовка для Cisco Cisco Packet Data Gateway (PDG)
show card
show card info (ASR 5000) ▀
Cisco ASR 5x00 Statistics and Counters Reference ▄
2869
show card info (ASR 5000)
Table 218.
show card info (ASR 5000)
Command Output Descriptions
Field
Applicable Card(s)
Description
Slot Type
All
Displays the acronym for the card type.
Card Type
All
Indicates the type of card installed.
Operational
State
State
All
Displays the operational state of the card. The possible operational states are:
Active: Indicates that the card is an active component that will be used to
process subscriber data sessions.
process subscriber data sessions.
Standby: Indicates that the card is a redundant component. Redundant
components will become active through manual configuration or automatically
should a failure occur.
components will become active through manual configuration or automatically
should a failure occur.
Offline: Indicates that the card is installed but is not ready to process subscriber
data sessions. This could be because it is not completely installed (such as, the
card interlock switch is not locked}. Refer to the ASR 5000 Installation Guide
for additional information.
data sessions. This could be because it is not completely installed (such as, the
card interlock switch is not locked}. Refer to the ASR 5000 Installation Guide
for additional information.
Desired Mode
Processing Cards,
SPIOs and line
cards only
SPIOs and line
cards only
Displays the configured mode of the card. Through software configuration the card could
be placed into either the active or standby mode.
be placed into either the active or standby mode.
Last State
Change
Change
All
Displays the time of the last operational state change for the card.
Administrative
State
State
All
Indicates whether or not the card has been configured for use via software. If it has been
configured, Enabled will be displayed. If not, Disabled will be displayed.
configured, Enabled will be displayed. If not, Disabled will be displayed.
Card Lock
All
Displays whether or not the card’s interlock switch is Locked or Unlocked.
Halt Issued
All
Displays whether or not this card was the target of a halt command issued by an
administrator or operator. The halt command stops all tasks and processes running on the
card. If the card has been halted, a Yes will be displayed. If not, a No will be displayed.
administrator or operator. The halt command stops all tasks and processes running on the
card. If the card has been halted, a Yes will be displayed. If not, a No will be displayed.
Reboot Pending
All
Displays whether or not the card will be undergoing a reboot. If the card is being
rebooted, a Yes will be displayed. If not, a No will be displayed.
rebooted, a Yes will be displayed. If not, a No will be displayed.