для Cisco Cisco Packet Data Gateway (PDG)
Troubleshooting
▀ Detecting Faulty Hardware
▄ ASR 5500 System Administration Guide, StarOS Release 17
184
Color
Description
Troubleshooting
Verify that the card is properly installed per the instructions in the ASR 5500
Installation Guide.
Installation Guide.
If all of the above suggestions have been verified, it is possible that the FSC is not
functional. Please contact your service representative.
functional. Please contact your service representative.
FSC Active LED States
The Active LED on the FSC indicates that the software is loaded on the card and that the card is ready for operation.
When the system first boots up, all installed FSCs are booted into ready mode.
When the system first boots up, all installed FSCs are booted into ready mode.
The possible states for this LED are described in the following table. If the LED is not green, use the troubleshooting
information in the table to diagnose the problem.
information in the table to diagnose the problem.
Table 25. FSC Active LED States
Color
Description
Troubleshooting
Green
Card is active.
The first time power is applied to the system, all of the FSCs should be booted
into the ready mode. Therefore, this LED should be on.
into the ready mode. Therefore, this LED should be on.
Blinking
Green
Green
Tasks or processes being migrated
from an active FSC to a standby
FSC.
from an active FSC to a standby
FSC.
Verify that the Redundancy LED on a standby FSC is also blinking green. If
so, there is an issue with the active FSC and it is transferring its processes.
so, there is an issue with the active FSC and it is transferring its processes.
Refer to Monitoring the System for information on determining the status of
the FSC and system software processes and functionality.
the FSC and system software processes and functionality.
None
Card is not receiving power.
OR
Card is in Standby Mode.
OR
Card is in Standby Mode.
Verify that the Run/Fail LED is green. If so, the card is receiving power and
POST results are positive. If it is off, refer to
POST results are positive. If it is off, refer to
for
troubleshooting information.
Check the state of the Redundancy LED. If it is green, the card is in standby
mode.
mode.
FSC Redundancy LED States
The Redundancy LED on the FSC indicates that software is loaded on the card, but it is serving as a redundant
component. FSC support n+1 redundancy; the Redundancy LED should be green on only one FSC for normal system
operation.
component. FSC support n+1 redundancy; the Redundancy LED should be green on only one FSC for normal system
operation.
The possible states for this LED are described in the following table. If the LED is not green, use the troubleshooting
information in the table to diagnose the problem.
information in the table to diagnose the problem.