для Cisco Cisco Packet Data Gateway (PDG)
Troubleshooting
▀ Detecting Faulty Hardware
▄ ASR 5000 System Administration Guide, StarOS Release 16
210
Table 24.
SPIO Active LED States
Color
Description
Troubleshooting
Green
Card is active.
None needed for SPIO in slot 24. If green for SPIO in slot 25, then verify that SPIO in slot 24 is
installed properly.
installed properly.
None
Card is not
receiving power.
OR
Card in Standby
Mode.
receiving power.
OR
Card in Standby
Mode.
Verify that the Run/Fail LED is green. If so, the card is receiving power and POST test results are
positive. If it is off, refer to
positive. If it is off, refer to
for troubleshooting information.
Check the state of the Standby LED. If it is green, the card is in standby mode. This is normal for
the SPIO in slot 25 since the chassis automatically places the card into standby mode at boot up.
the SPIO in slot 25 since the chassis automatically places the card into standby mode at boot up.
SPIO Standby LED States
The Standby LED on the SPIO indicates that software is loaded on the card, but it is serving as a redundant component.
For the SPIO installed in slot 25, this LED should be green for normal operation. For the SPIO installed in slot 24, this
LED should be off for normal operation.
For the SPIO installed in slot 25, this LED should be green for normal operation. For the SPIO installed in slot 24, this
LED should be off for normal operation.
The possible states for this LED are described in the following table. If the LED is not green, use the troubleshooting
information in the table to diagnose the problem.
information in the table to diagnose the problem.
Table 25.
SPIO Standby LED States
Color
Description
Troubleshooting
Green
Card is in
redundant mode.
redundant mode.
None needed for SPIO in slot 25. If green for SPIO in slot 24, check the status of the SMC installed
in slot 8.
in slot 8.
If the SMC in slot 8 is in standby mode, it is possible that there is a problem.
Monitoring the System for show commands, the outputs of which will assist in further determining
the problem.
the problem.
System Logs or information on how to view logs.
The SNMP MIB Reference for information on associated status and alarm conditions.
None
Card is not
receiving power.
OR
Card is in Active
Mode.
receiving power.
OR
Card is in Active
Mode.
Verify that the Run/Fail LED is green. If so, the card is receiving power and POST test results are
positive. If it is off, refer to
positive. If it is off, refer to
for troubleshooting information.
Check the state of the Active LED. If it is green, the card is in active mode. This is normal for the
SPIO in slot 24 since the chassis automatically makes the card active at boot up.
SPIO in slot 24 since the chassis automatically makes the card active at boot up.