для Cisco Cisco Packet Data Gateway (PDG)
Interchassis Session Recovery
▀ Configuring Interchassis Session Recovery (ICSR)
▄ ASR 5000 System Administration Guide, StarOS Release 16
338
Configuring the SRP Context Interface Parameters
This procedure configures the communication interface with the IP address and port number within the SRP context.
This interface supports interchassis communication.
This interface supports interchassis communication.
Important:
CLI commands must be executed on both chassis. Log onto both chassis before continuing. Always
make configuration changes on the primary chassis first.
configure
context <vpn_ctxt_name> [-noconfirm]
interface <srp_if_name>
ip-address { <ip_address> | <ip_address>/<mask> }
exit
exit
port ethernet <slot_num>/<port_num>
description <des_string>
medium { auto | speed { 10 | 100 | 1000 } duplex { full | half } }
no shutdown
bind interface <srp_if_name> <srp_ctxt_name>
end
Verifying SRP Configuration
Step 1
Verify that your SRP contexts were created and configured properly by entering the show srp info command (Exec
Mode).
Mode).
Sample output for this command as shown. In this example, an SRP context called srp1 was configured with default
parameters.
parameters.
Service Redundancy Protocol:
----------------------------------------------------------------------
Context: srp1
Local Address: 0.0.0.0
Chassis State: Init
Chassis Mode: Backup
Chassis Priority: 125
Local Tiebreaker: 00-00-00-00-00-00
Route-Modifier: 34
Peer Remote Address: 0.0.0.0
Peer State: Init
Peer Mode: Init
----------------------------------------------------------------------
Context: srp1
Local Address: 0.0.0.0
Chassis State: Init
Chassis Mode: Backup
Chassis Priority: 125
Local Tiebreaker: 00-00-00-00-00-00
Route-Modifier: 34
Peer Remote Address: 0.0.0.0
Peer State: Init
Peer Mode: Init