для Cisco Cisco Packet Data Gateway (PDG)
radius allow
This command configures the system behavior for allowing subscriber sessions when RADIUS accounting
and/or authentication is unavailable.
and/or authentication is unavailable.
Product
All products used in CDMA deployments
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > AAA Server Group Configuration
configure > context context_name > aaa group group_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-aaa-group)#
Syntax Description
[ no ] radius allow { authentication-down | accounting-down }
no
Specifies that the specified option is to be disabled.
authentication-down
Allows sessions while authentication is not available (down).
Default: Disabled
accounting-down
Allows sessions while accounting is unavailable (down).
Default: Enabled
Usage Guidelines
Allow sessions during system troubles when the risk of IP address and/or subscriber spoofing is minimal. The
denial of sessions may cause dissatisfaction with subscribers at the cost/expense of verification and/or
accounting data.
denial of sessions may cause dissatisfaction with subscribers at the cost/expense of verification and/or
accounting data.
Please note that this command is applicable ONLY to CDMA products. To configure this functionality
in UMTS/LTE products (GGSN/P-GW/SAEGW), use the command mediation-device
delay-GTP-response in APN Configuration mode.
in UMTS/LTE products (GGSN/P-GW/SAEGW), use the command mediation-device
delay-GTP-response in APN Configuration mode.
Important
Command Line Interface Reference, Modes A - B, StarOS Release 19
76
AAA Server Group Configuration Mode Commands
radius allow