для Cisco Cisco Packet Data Gateway (PDG)
ftp client-ip-address
This command allows you to define rule expressions to match IP address of the FTP client.
Product
ACS
Privilege
Security Administrator, Administrator
Command Modes
Exec > ACS Configuration > Ruledef Configuration
active-charging service service_name > ruledef ruledef_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-acs-ruledef)#
Syntax Description
[ no ] ftp client-ip-address operator ipv4/ipv6_address
no
If previously configured, deletes the specified rule expression from the current ruledef.
operator
Specifies how to match.
operator must be one of the following:
• !=: Does not equal
• <=: Lesser than or equals
• =: Equals
• >=: Greater than or equals
ipipv4/ipv6_address
Specifies the FTP client IP address to match.
ipv4/ipv6_address must be in IPv4 dotted-decimal or IPv6 colon-separated-hexadecimal notation.
Usage Guidelines
Use this command to define rule expressions to match an FTP client IP address, which will be either the IP
source address or the IP destination address, depending on the direction.
source address or the IP destination address, depending on the direction.
Command Line Interface Reference, Modes A - B, StarOS Release 19
835
ACS Ruledef Configuration Mode Commands
ftp client-ip-address