для Cisco Cisco Packet Data Gateway (PDG)
threshold ipsec-ike-failrate
Configures a threshold for the percentage of IPSec IKE failures.
Product
HA
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > HA Service Configuration
configure > context context_name > ha-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-ha-service)#
Syntax Description
threshold ipsec-ike-failrate high_thresh [ clear low_thresh ]
no threshold ipsec-ike-failrate
no threshold ipsec-ike-failrate
no
Deletes the alert or alarm.
high_thresh
Default: 0
Specifies the high threshold percentage of IPSec IKE failures per second that must be met or exceeded within
the polling interval to generate an alert or alarm.
the polling interval to generate an alert or alarm.
high_thresh is an integer from 0 through 100.
clear low_thresh
Default:0
Specifies the low threshold percentage of IPSec IKE failures per second that must be met or exceeded within
the polling interval to clear an alert or alarm.
the polling interval to clear an alert or alarm.
low_thresh is an integer from 0 through 100.
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm model,
the system assumes it is identical to the high threshold.
the system assumes it is identical to the high threshold.
Important
Command Line Interface Reference, Modes G - H, StarOS Release 19
1295
HA Service Configuration Mode Commands
threshold ipsec-ike-failrate