для Cisco Cisco Packet Data Gateway (PDG)
sccp
Configures Signaling Connection Control Part (SCCP) related parameters for HNB-GW on the circuit switched
(CS) network.
(CS) network.
Product
HNB-GW
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > HNB-CS Network Configuration
configure > cs-network cs_instance
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-cs-network-
instance_id
)#
Syntax Description
[ default | no ] sccp calling-party-address
default
Restores the configuration to its default setting. By default, the calling party address is not included in the
outgoing SCCP CR message.
outgoing SCCP CR message.
no
If previously enabled, removes the configuration and restores the default setting.
calling-party-address
Specifies to include the optional calling-party-address IE in the outgoing SCCP CR message.
Usage Guidelines
Use this command to enable HNB-GW to include the optional calling party address in the outgoing Signaling
Connection Control Part (SCCP) Connection Request (CR) message on the circuit switched network.
Connection Control Part (SCCP) Connection Request (CR) message on the circuit switched network.
Examples
The following command enables the calling party address to be sent in the SCCP CR message:
sccp calling-party-address
sccp calling-party-address
Command Line Interface Reference, Modes G - H, StarOS Release 19
1494
HNB-CS Network Configuration Mode Commands
sccp