для Cisco Cisco Packet Data Gateway (PDG)
task facility ipsecmgr
Configures IPSec manager settings.
Product
All
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]
host_name
(config)#
Syntax Description
task facility ipsecmgr { ikev1 { task-count { increased | normal } } | task-count { increased | normal } }
ikev1 { task-count { increased | normal } }
Default: normal
Adjusts the IPSec manager task count to support EHA for IKEv1. See task-count below.
task-count { increased | normal }
Default: normal
Adjusts the IPSec manager task count to support EHA.
increased: Starts additional IPSec manager tasks operating on the packet processing cards. In increased mode,
they run on all but demux packet processing cards. Also, all the IPSec managers start at the same time when
an active non-demux card is detected and IPSec is configured.
they run on all but demux packet processing cards. Also, all the IPSec managers start at the same time when
an active non-demux card is detected and IPSec is configured.
normal: Uses the standard algorithm for allocating memory for IPSec manager tasks. In normal mode, IPSec
managers do not run on session packet processing cards.
managers do not run on session packet processing cards.
If task-count is set to normal and session recovery is enabled, IPSec manager tasks are not allowed to
start on most packet processing cards. Because the resources are not reserved, IPSec managers in normal
mode only run on demux packet processing cards.
start on most packet processing cards. Because the resources are not reserved, IPSec managers in normal
mode only run on demux packet processing cards.
Caution
Usage Guidelines
Sets IPSec manager parameters for all IPSec managers in the system.
Command Line Interface Reference, Modes G - H, StarOS Release 19
412
Global Configuration Mode Commands (T-threshold phspc)
task facility ipsecmgr