для Cisco Cisco Packet Data Gateway (PDG)
threshold aaa-auth-failure-rate
Configures authentication failure rate, alarm or alert thresholds for the system.
Product
PDSN
GGSN
HA
ASN-GW
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]
host_name
(config)#
Syntax Description
threshold aaa-auth-failure-rate high_thresh [ clear low_thresh ]
default threshold aaa-auth-failure-rate
default threshold aaa-auth-failure-rate
high_thresh
Default: 5
Specifies the high threshold percent of authentication failures that must be met or exceeded within the polling
interval to generate an alert or alarm. high_thresh is an integer from 0 through 100.
interval to generate an alert or alarm. high_thresh is an integer from 0 through 100.
clear
Allows the configuration of Specifies the low threshold.
low_thresh
Default: 5
Specifies the low threshold percent of authentication failures that maintains a previously generated alarm
condition. If the percentage of failures falls beneath the low threshold within the polling interval, a clear alarm
will be generated. low_thresh is an integer from 0 through 100.
condition. If the percentage of failures falls beneath the low threshold within the polling interval, a clear alarm
will be generated. low_thresh is an integer from 0 through 100.
Command Line Interface Reference, Modes G - H, StarOS Release 19
443
Global Configuration Mode Commands (T-threshold phspc)
threshold aaa-auth-failure-rate