для Cisco Cisco Packet Data Gateway (PDG)
threshold per-service-pdg-sessions
Configures alarm or alert thresholds for the number of Packet Data Gateway (PDG) sessions per PDG service
in the system.
in the system.
Product
PDG/TTG
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]
host_name
(config)#
Syntax Description
threshold per-service-pdg-sessions high_thresh [ clear low_thresh ]
high_thresh
Default: 0
Specifies the high threshold number of PDG sessions for any one PDG service that must be met or exceeded
within the polling interval to generate an alert or alarm.
within the polling interval to generate an alert or alarm.
high_thresh is an integer from 0 through 1000000. A value of 0 disables the threshold.
clear low_thresh
Default: 0
Specifies the low threshold number of PDG sessions for any one PDG service that maintains a previously
generated alarm condition. If the number of PDG sessions falls beneath the low threshold within the polling
interval, a clear alarm will be generated.
generated alarm condition. If the number of PDG sessions falls beneath the low threshold within the polling
interval, a clear alarm will be generated.
low_thresh is an integer from 0 through 1000000. A value of 0 disables the threshold.
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm model,
the system assumes it is identical to the high threshold.
the system assumes it is identical to the high threshold.
Important
Usage Guidelines
Monitor and set alarms or alerts when the number of PDG sessions for any PDG service in the system is equal
to or greater than the set limit.
to or greater than the set limit.
Command Line Interface Reference, Modes G - H, StarOS Release 19
578
Global Configuration Mode Commands (T-threshold phspc)
threshold per-service-pdg-sessions