для Cisco Cisco Packet Data Gateway (PDG)
qci
This command configures various DDN parameters for a quality of class identifier (QCI) in a DDN APN
Profile.
Profile.
Product
SGW
Privilege
Administrator, Security Administrator
Command Modes
Exec > Global Configuration > DDN APN Profile Configuration
configure > ddn-apn-profile ddn_apn_profile_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(ddn-apn-profile
profile_name)#
Syntax Description
qci qci_number ddn { failure-action pkt-drop-timer duration_seconds | ignore-ddn-timers | min-buf-size
size_kb
[ remove ] qci qci_number
remove qci qci_number
Removes the DDN configuration for the specified QCI value.
qci
Specifies the quality of class identifier (QCI) to be configured. Valid entries are from 1 to 254. A maximum
of 4 QCI values are supported for configuration per ddn-apn-profile.
of 4 QCI values are supported for configuration per ddn-apn-profile.
ddn
Specifies a DDN parameter to be configured.
failure-action pkt-drop-timer duration_seconds
This is the time for which no data for UE is buffered. This timer activates the moment a DDN failure is
received. This value supersedes the one configured at sgw-service level. When a DDN failure is received, the
minimum of the pkt-drop-timer configured for all QCIs having data is started.
received. This value supersedes the one configured at sgw-service level. When a DDN failure is received, the
minimum of the pkt-drop-timer configured for all QCIs having data is started.
ignore-ddn-timers
If the DDN Delay timer is started and data arrives on a bearer with a QCI for which this flag is set, then the
S-GW will stop that timer and send the DDN. The ignore-ddn-timers configuration is applicable only to the
S-GW will stop that timer and send the DDN. The ignore-ddn-timers configuration is applicable only to the
Command Line Interface Reference, Modes C - D, StarOS Release 19
1719
DDN APN Profile Configuration Mode Commands
qci