для Cisco Cisco Packet Data Gateway (PDG)
ipv6 rri-route
Configures High Availability (HA) IPv6 routing parameters for Reverse Route Injection (RRI). (VPC-VSM
only)
only)
Product
SecGW
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-ctx)#
Syntax Description
ipv6 rri-route network-mode { L2 | L3 } { clear_loopback_ip | rri-ip virtual_ipv6_address } { ipv6_address
| next-hop nexthop_address } interface interface_name [ vrf vrf_name ]
no ipv6 rri-route network-mode { L2 | L3 } { clear_loopback_ip | rri-ip virtual_ipv6_address } {
ipv6_address | next-hop nexthop_address } interface interface_name [ vrf vrf_name ]
ipv6_address | next-hop nexthop_address } interface interface_name [ vrf vrf_name ]
no
Disables the specified RRI route.
network-mode { L2 | L3 }
Specifies the RRI route network mode type as Layer 2 (L2) or Layer 3 (L3).
clear_loopback_ip
Specifies the loopback address for clear traffic in IPv4 dotted-decimal or IPv6 colon-separated-hexadecimal
notation.
notation.
rri-ip virtual_ipv6_address
Specifies the use of a virtual IP address on both Primary and Secondary for RRI. virtual_ipv6_address is
expressed in IPv6 colon-separated-hexadecimal notation.
expressed in IPv6 colon-separated-hexadecimal notation.
ipv6_address
Specified in IPv6 colon-separated-hexadecimal notation.
Command Line Interface Reference, Modes C - D, StarOS Release 19
767
Context Configuration Mode Commands I-M
ipv6 rri-route