для Cisco Cisco Tunnel Terminating Gateway (TTG)
ping sec
Default: 20
This timer is used to specify the timeout to send ping message to make the connection alive in seconds.
sec must be an integer from 1 to 5000.
ping-response sec
Default: 30
This timer is used to specify the timeout for ping response in seconds.
sec must be an integer from 1 to 5000.
query-response sec
Default: 6
This timer is used to specify the timeout for query response in seconds.
sec must be an integer from 1 to 5000.
release-response sec
Default: 30
This timer is used to specify the timeout for release response in seconds.
sec must be an integer from 1 to 5000.
tcp-retry sec
Default: 15
This timer is used to specify the timeout interval for retrying failed TCP connection in seconds.
sec must be an integer from 1 to 5000.
default
Returns the command to the default settings. See keywords above for specific defaults.
no
Deletes the value configured for the specified timer.
Usage Guidelines
Use this command to configure timeout values for NPDB client.
When CSCF service is started, NPDB client establishes TCP connections with NPDB primary and secondary
servers (if configured) and sets the connection path by sending Bind message to server. If NPDB client fails
to establish TCP connection to either of the servers, it will retry the connection every TCPRetryTimer interval
until it is successful. When the connection is successful, NPDB client will go to the connected state and will
start PingTimer. Whenever NPDB client receives service request from CSCF core, it sends the request based
on the connected state of the server(s); it should always give higher preference to the primary server. When
it fails to send a query message to server, NPDB client returns failure to the core. If both servers are not in
connected state, NPDB client will send failure message to CSCF core.
servers (if configured) and sets the connection path by sending Bind message to server. If NPDB client fails
to establish TCP connection to either of the servers, it will retry the connection every TCPRetryTimer interval
until it is successful. When the connection is successful, NPDB client will go to the connected state and will
start PingTimer. Whenever NPDB client receives service request from CSCF core, it sends the request based
on the connected state of the server(s); it should always give higher preference to the primary server. When
it fails to send a query message to server, NPDB client returns failure to the core. If both servers are not in
connected state, NPDB client will send failure message to CSCF core.
Command Line Interface Reference, Modes C - D, StarOS Release 19
1399
CSCF NPDB Client Configuration Mode Commands
timeout