для Cisco Cisco Packet Data Gateway (PDG)
area authentication
Enables authentication for the specified OSPF area.
Product
PDSN
HA
GGSN
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > OSPF Configuration
configure > context context_name > router ospf
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-ospf)#
Syntax Description
[
no
]
area
{
ip_address
|
decimal_value
}
authentication
[
message-digest
]
no
Disables authentication for the specified area.
ip_address
Specifies the IP address of the area where authentication will be enabled in IPv4 dotted-decimal notation.
decimal_value
Specifies the identification number of the area where authentication will be enabled. This must be an integer
from 0 through 4294967295.
from 0 through 4294967295.
authentication
Sets the OSPF authentication type to use the simple authentication method.
message-digest
Sets the OSPF authentication type to use the message digest 5 (MD5) authentication method.
Usage Guidelines
Use this command to enable authentication of OPSF areas.
Command Line Interface Reference, Modes I - Q, StarOS Release 19
1119
OSPF Configuration Mode Commands
area authentication