для Cisco Cisco Packet Data Gateway (PDG)
area virtual link intervals
Configures the interval or delay type, and the delay time in seconds, for the virtual link between an area that
cannot be physically connected to the network backbone and an area that is physically connected to the network
backbone.
cannot be physically connected to the network backbone and an area that is physically connected to the network
backbone.
Product
PDSN
HA
GGSN
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > OSPF Configuration
configure > context context_name > router ospf
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-ospf)#
Syntax Description
[
no
]
area
{
ip_address
|
decimal_value
}
virtual-link router_id_address
[
dead-interval dead_value
] [
hello-interval hello_value
] [
retransmit-interval rt_value
] [
transmit-delay td_value
]
no
Disables the area virtual link intervals.
ipaddress
Specifies the IP address of the area in IPv4 dotted-decimal notation.
decimal_value
Specifies the identification number of the transit area as an integer from 0 through 4294967295.
router_id_address
Specifies the router id of the ABR to be linked to in IPv4 dotted-decimal notation.
dead-interval dead_value
Specifies The interval (in seconds) that the router should wait, during which time no packets are received and
after the router considers a neighboring router to be off-line. dead_value must be an integer from 1 through
65535.
after the router considers a neighboring router to be off-line. dead_value must be an integer from 1 through
65535.
Command Line Interface Reference, Modes I - Q, StarOS Release 19
1131
OSPF Configuration Mode Commands
area virtual link intervals