для Cisco Cisco Packet Data Gateway (PDG)
diameter origin end-point
This command is used to bind/associate a pre-configured Diameter host/realm (AF) over Rx interface with a
PCC-AF-Service to be used for subscriber service control and AF profile management.
PCC-AF-Service to be used for subscriber service control and AF profile management.
Product
IPCF
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > PCC AF Service Configuration
configure > context context_name > pcc-af-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-imsapp-service)#
Syntax Description
diameter origin endpoint dia_endpoint_name
no diameter origin endpoint
no diameter origin endpoint
no
Removes the associated Diameter Origin Endpoint configuration from PCC-AF-Service instance configured
for IPCF configuration.
for IPCF configuration.
any
Sets the PCC-AF-Service instance to use any available AF node over Rx interface for AF support.
dia_endpoint_name
The dia_endpoint_name is a predefined Diameter origin endpoint node and must be an alphanumerical string
from 1 through 63 characters.
from 1 through 63 characters.
Usage Guidelines
Use this command to bind the AF node over Rx interface by associating a pre-configured Diameter Origin
Endpoint with a PCC-AF-Service.
Endpoint with a PCC-AF-Service.
The Diameter origin endpoint must be a pre-configured instance in the Context Configuration Mode. For
more information on Diameter origin endpoint configuration, refer Diameter Endpoint Configuration Mode
Commands chapter.
more information on Diameter origin endpoint configuration, refer Diameter Endpoint Configuration Mode
Commands chapter.
Command Line Interface Reference, Modes I - Q, StarOS Release 19
1264
PCC-AF-Service Configuration Mode Commands
diameter origin end-point