для Cisco Cisco Packet Data Gateway (PDG)
threshold init-rrq-rcvd-rate
Sets an alarm or alert based on the average number of calls setup per second for the context.
Product
PDSN
Privilege
Security Administrator, Administrator
Command Modes
Exec > Global Configuration > Context Configuration > PDSN Service Configuration
configure > context context_name > pdsn-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-pdsn-service)#
Syntax Description
threshold init-rrq-rcvd-rate high_thresh
[
clear low_thresh
]
no threshold init-rrq-rcvd-rate
no
Deletes the alert or alarm.
high_thresh
Default: 0
The high threshold average number of calls setup per second must be met or exceeded within the polling
interval to generate an alert or alarm. It can be configured to any integer value between 0 and 1000000.
interval to generate an alert or alarm. It can be configured to any integer value between 0 and 1000000.
clear low_thresh
Default:0
The low threshold average number of calls setup per second that must be met or exceeded within the polling
interval to clear an alert or alarm. It can be configured to any integer value between 0 and 1000000.
interval to clear an alert or alarm. It can be configured to any integer value between 0 and 1000000.
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm model,
the system assumes it is identical to the high threshold.
the system assumes it is identical to the high threshold.
Important
Usage Guidelines
Use this command to set an alert or an alarm when the average number of calls setup per second is equal to
or greater than a specified number of calls per second.
or greater than a specified number of calls per second.
Command Line Interface Reference, Modes I - Q, StarOS Release 19
1623
PDSN Service Configuration Mode Commands
threshold init-rrq-rcvd-rate