для Cisco Cisco Tunnel Terminating Gateway (TTG)
Do not change the version, minpoll or maxpoll keyword settings unless instructed to do so by Cisco
TAC.
TAC.
Important
version number
Specifies the network timing protocol version to use for server communications as an integer from 1 to 4.
Default: 4 (RFC 5905)
Default: 4 (RFC 5905)
minpoll poll_period
Specifies the minimum polling interval (in seconds) for NTP messages as a power of 2. poll_period is the
exponent (power of) expressed as an integer from 6 through 17. For example, if you specify the number 6,
the value is 2^6 and the resultant poll period is 64 seconds. Default: 6
exponent (power of) expressed as an integer from 6 through 17. For example, if you specify the number 6,
the value is 2^6 and the resultant poll period is 64 seconds. Default: 6
maxpoll poll_period
Specifies the maximum polling interval (in seconds) for NTP messages as a power of 2. poll_period is the
exponent (power of) expressed as an integer from 6 through 17. For example, if you specify the number 10,
the value is 2^10 and the resultant poll period is 1024 seconds. Default: 10
exponent (power of) expressed as an integer from 6 through 17. For example, if you specify the number 10,
the value is 2^10 and the resultant poll period is 1024 seconds. Default: 10
Usage Guidelines
Configure the NTP servers in response to network changes.
Refer to the System Administration Guide for important information on configuring NTP servers with local
sources, and using a load balancer to communicate with external NTP servers.
sources, and using a load balancer to communicate with external NTP servers.
Adding, removing, or modifying an NTP server configuration entry causes the NTP client to restart itself
and resynchronize with all configured NTP servers.
and resynchronize with all configured NTP servers.
Important
Examples
The following command adds the NTP server with address 10.2.3.4 to the list of NTP servers.
server 10.2.3.4
server 10.2.3.4
Command Line Interface Reference, Modes I - Q, StarOS Release 19
1067
NTP Configuration Mode Commands
server