для Cisco Cisco Packet Data Gateway (PDG)
validation-mode
Configures the type of validation to be performed on messages received by this service.
Product
ePDG
P-GW
SAEGW
SGSN
The ePDG and SGSN are not currently supported on the ASR 5500 platform.
Important
Privilege
Administrator
Command Modes
Exec > Global Configuration > Context Configuration > eGTP Service Configuration
configure > context context_name > egtp-service service_name
Entering the above command sequence results in the following prompt:
[
context_name
]
host_name
(config-egtp-service)#
Syntax Description
validation-mode { custom1 | standard }
default validation-mode
default validation-mode
default
Returns the command to the default setting of standard.
{ custom1 | standard }
custom1: Specifies that the message should be validated based on a vendor-specific set of mandatory elements.
standard: Specifies that the message should be validated based on the set of mandatory elements as defined
in 3GPP 29.274. This is the default option on an S4-SGSN.
in 3GPP 29.274. This is the default option on an S4-SGSN.
Usage Guidelines
Use this command to specify the type of validation performed on messages received by this service. The
information elements contained in messages have mandatory elements and conditional elements. The standard
set of elements, as defined by 3GPP 29.274 is checked if this command is set to "standard". The custom1
setting is for a vendor-specific set of mandatory elements.
information elements contained in messages have mandatory elements and conditional elements. The standard
set of elements, as defined by 3GPP 29.274 is checked if this command is set to "standard". The custom1
setting is for a vendor-specific set of mandatory elements.
Command Line Interface Reference, Modes E - F, StarOS Release 19
76
eGTP Service Configuration Mode Commands
validation-mode