для Cisco Cisco Packet Data Gateway (PDG)
Firewall-and-NAT Action Configuration Mode
Commands
Commands
The Firewall-and-NAT Action Configuration Mode enables configuring Stateful Firewall (FW) and Network
Address Translation (NAT) actions.
Address Translation (NAT) actions.
Command Modes
Exec > ACS Configuration > Firewall-and-NAT Action Configuration
active-charging service service_name > fw-and-nat action action_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-fw-and-nat-action)#
This configuration mode is only available in release 11.0 and later releases. This configuration mode must
be used to configure Action-based Stateful Firewall and NAT features.
be used to configure Action-based Stateful Firewall and NAT features.
Important
The commands or keywords/variables that are available are dependent on platform type, product version,
and installed license(s).
and installed license(s).
Important
•
•
•
Command Line Interface Reference, Modes E - F, StarOS Release 19
1669