для Cisco Cisco Packet Data Gateway (PDG)
firewall malformed-packets
This command configures Stateful Firewall action on malformed packets. In release 12.0, this command
supports ICMPv6 and IPv6 packets.
supports ICMPv6 and IPv6 packets.
Product
PSF
Privilege
Security Administrator, Administrator
Command Modes
Exec > ACS Configuration > Firewall-and-NAT Policy Configuration
active-charging service service_name > fw-and-nat policy policy_name
Entering the above command sequence results in the following prompt:
[local]
host_name
(config-fw-and-nat-policy)#
Syntax Description
firewall malformed-packets { drop | permit }
default firewall malformed-packets
default firewall malformed-packets
default
Configures the default setting.
Default: permit
drop
Drops malformed packets.
permit
Permits malformed packets.
Usage Guidelines
Use this command to configure Stateful Firewall action on malformed packets.
For NAT-only calls, malformed packets are always permitted.
Examples
The following command specifies Stateful Firewall to drop malformed packets:
firewall malformed-packets drop
firewall malformed-packets drop
Command Line Interface Reference, Modes E - F, StarOS Release 19
1695
Firewall-and-NAT Policy Configuration Mode Commands
firewall malformed-packets