для Cisco Cisco ASR 5000
GTPC Overload Control Profile Configuration Mode Commands
inclusion-frequency ▀
Command Line Interface Reference, StarOS Release 18 ▄
6135
Default: 5%
Usage
Use this command to configure parameters to decide inclusion frequency of Overload Control Information
IE. How often the sender includes the overload control information is implementation specific. The network
element ensures that new/updated overload control information is propagated to the target receivers within an
acceptable delay so that the purpose of the information, effective load balancing, is achieved.
If no parameters are specified, the system will use the default settings.
The Overload Control Profile must be associated with a P-GW, S-GW, or SAEGW service using one of the
following commands:
IE. How often the sender includes the overload control information is implementation specific. The network
element ensures that new/updated overload control information is propagated to the target receivers within an
acceptable delay so that the purpose of the information, effective load balancing, is achieved.
If no parameters are specified, the system will use the default settings.
The Overload Control Profile must be associated with a P-GW, S-GW, or SAEGW service using one of the
following commands:
P-GW:
associate
command in P-GW Service Configuration Mode
S-GW:
associate
command in S-GW Service Configuration Mode
SAEGW:
associate
commands in both P-GW and S-GW Service Configuration modes
Example
The following example configures the inclusion-frequency change factor to 10.
inclusion-frequency change-factor 10