для Cisco Cisco Packet Data Gateway (PDG)
APN Configuration Mode Commands
dhcp context-name ▀
Command Line Interface Reference, StarOS Release 18 ▄
1337
dhcp context-name
Configures the name of the context on the system in which Dynamic Host Control Protocol (DHCP) functionality is
configured.
configured.
Product
GGSN
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > APN Configuration
configure > context context_name > apn apn_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-apn)#
Syntax
[ no ] dhcp context-name name
no
Removes a previously configured context name.
name
Specifies the name of a context configured on the system in which one or more DHCP services are
configured.
configured.
name
is an alphanumeric string of 1 through 79 characters that is case sensitive.
Usage
If the APN is to support dynamic address assignment via DHCP (either the proxy or relay mode), this
parameter must be configured to point the APN to the name of a pre-configured context on the chassis in
which one or more DHCP services are configured.
The command can be used to identify a single DHCP service instance within the specified context to use to
facilitate the address assignment.
parameter must be configured to point the APN to the name of a pre-configured context on the chassis in
which one or more DHCP services are configured.
The command can be used to identify a single DHCP service instance within the specified context to use to
facilitate the address assignment.
Example
The following command configures the APN to look for DHCP services in a context called
dhcp-ctx:
dhcp context-name dhcp-ctx