для Cisco Cisco Packet Data Gateway (PDG)
CSCF Security Configuration Mode Commands
bad-request-weight ▀
Command Line Interface Reference, StarOS Release 18 ▄
3277
bad-request-weight
Sets a severity number for bad registration requests used in calculating a value for determining when to suspend
registration attempts.
registration attempts.
Important:
The system will ignore the configuration of this command unless the
dos-prevention
command
has been enabled.
Product
SCM (P-CSCF, A-BG)
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > CSCF Service Configuration > Proxy-CSCF Configuration >
CSCF Security Configuration
CSCF Security Configuration
configure > context context_name > cscf service service_name > proxy-cscf > security-
parameters
parameters
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-security-parameters)#
Syntax
bad-request-weight weight
default bad-request-weight
default
Sets/restores the default value assigned to the specified command.
weight
Default: 2
Assigns a weight to a bad registration request. Defines the severity of a single bad request.
Assigns a weight to a bad registration request. Defines the severity of a single bad request.
weight
must be an integer from 1 to 5.
Usage
Use this command to define the severity of bad registration request. This parameter is used in calculating the
current number of request failures to compare to the
current number of request failures to compare to the
per-aor-failure-limit
and the
per-ip-failure-
limit
. Configuring this command with a lower number causes the system to suspend registration attempts
with repeated request failures much sooner than when configured with a higher number.
Example
The following command assigns a weight of
3
to a bad registration request:
bad-request-weight 3