для Cisco Cisco Packet Data Gateway (PDG)
ACS Charging Action Configuration Mode Commands
nexthop-forwarding-address ▀
Command Line Interface Reference, StarOS Release 18 ▄
423
nexthop-forwarding-address
This command allows you to configure the nexthop forwarding address.
Product
All
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Charging Action Configuration
active-charging service service_name > charging-action charging_action_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-charging-action)#
Syntax
nexthop-forwarding-address ipv4_address
no nexthop-forwarding-address
no
If previously configured, deletes the nexthop-forwarding-address configuration in the current charging action.
ipv4_address
Specifies the nexthop-forwarding-address for the current charging action.
ipv4_address
must be the nexthop forwarding address, and must be an IPv4 address.
Usage
Use this command to configure the nexthop-forwarding-address for a charging action. When an uplink packet
matches a rule and a charging action is applied to it this nexthop forwarding address is used.
There are different methods to configure a nexthop forwarding address, they are prioritized as follows:
matches a rule and a charging action is applied to it this nexthop forwarding address is used.
There are different methods to configure a nexthop forwarding address, they are prioritized as follows:
The nexthop forwarding address, if configured, in a redirect ACL is used
Else, the nexthop address configured in the charging action is used
Else, the nexthop address, if configured, in the IP pool is used
Example
The following command sets the nexthop forwarding address for the current charging action to
10.1.1.1
:
nexthop-forwarding-address 10.1.1.1