для Cisco Cisco Packet Data Gateway (PDG)
ACS Charging Action Configuration Mode Commands
xheader-insert ▀
Command Line Interface Reference, StarOS Release 18 ▄
445
Note that if the value of the key is changed on the fly, it will take effect only in case of new calls. Also, if the
per rulebase RSA encryption is also enabled in the same config, per charging-action RC4MD5 encryption
will take precedence over it.
per rulebase RSA encryption is also enabled in the same config, per charging-action RC4MD5 encryption
will take precedence over it.
key
specifies the key as an alphanumeric string of 8 through 15 characters.
encryption
specifies use of encryption.
The
key
can be configured either as plain text or encrypted. However, in the output of the
show
configuration
command it will always be displayed as encrypted. And, in the output of the
show
configuration showsecrets
command it will be displayed as plain text.
first-request-only
Specifies x-header insertion only for the first HTTP request in the IP flow. If not configured, the default
behavior is insertion for all requests.
behavior is insertion for all requests.
-noconfirm
Specifies that the command must execute without any prompts and confirmation from the user.
Usage
Use this command to enable x-header mode, and specify the x-header format name whose fields are to be
inserted in HTTP GET and POST request packets.
Also, see the
inserted in HTTP GET and POST request packets.
Also, see the
xheader-format
command in the ACS Configuration Mode Commands and ACS X-header
Format Configuration Mode Commands chapters.
Example
The following command enables x-header mode, and specifies the x-header format name as
test12
:
xheader-insert xheader-format test12