для Cisco Cisco Packet Data Gateway (PDG)
HeNB-GW Network Service Configuration Mode Commands
▀ default-paging-drx
▄ Command Line Interface Reference, StarOS Release 18
6332
default-paging-drx
This command is used to configure the Default paging DRX value that is sent to the MME(s) in the S1 SETUP request
message.
message.
Product
HeNB-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > HeNBGW-Network Service Configuration
configure > context
context_name
> henbgw-network-service
service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-henbgw-network-service)#
Syntax
default-paging-drx { v128 | v256 | v32 | v64 }
default default-paging-drx
default
Sets/Restores the default value assigned for Default-Paging-DRX for the configured HeNB-GW Network
service.
service.
default-paging-drx { v128 | v256 | v32 | v64 }
Any one of the following DRX values can be configured :
v128: Designates use of Paging DRX v128.
v256: Designates use of Paging DRX v256.
v32: Designates use of Paging DRX v32.
v64: Designates use of Paging DRX v64.
Usage
Use this command to configure the Default Paging DRX value for this HeNB-GW Network service.
Example
Following command configures v256 as the Default Paging DRX value on a specific HeNB-GW Network
service.
service.
default-paging-drx v256