для Cisco Cisco ASR 5700
Global Configuration Mode Commands (T-threshold phspc)
threshold fw-drop-packet ▀
Command Line Interface Reference, StarOS Release 17 ▄
5625
threshold fw-drop-packet
Configures alarm or alert thresholds for Stateful Firewall dropped packets.
Product
PSF
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold fw-drop-packet high_thresh [ clear low_thresh ]
default threshold fw-drop-packet
default
Configures this command with the default threshold settings.
Default: 0—disabled
Default: 0—disabled
high_thresh
Specifies the Stateful Firewall dropped packets threshold value, which if met or exceeded generates an alert
or alarm.
or alarm.
high_thresh
must be an integer from 0 through 1000000.
Default: 0
clear low_thresh
Specifies the Stateful Firewall dropped packets clear threshold value. If, in the same polling interval, the
threshold falls below
threshold falls below
low_thresh
a clear alarm is generated.
low_thresh
must be an integer from 0 through 1000000.
Default: 0
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the low threshold.
Usage
When the number of dropped packets exceed a given value, a threshold is raised and it is cleared when the
number of dropped packets fall below a value within the polling interval.
Refer to the
number of dropped packets fall below a value within the polling interval.
Refer to the
threshold poll
command to configure the polling interval and the
threshold monitoring
command to enable thresholding for this value.
Example