для Cisco Cisco ASR 5700
Global Configuration Mode Commands (T-threshold phspc)
threshold per-service-sgsn-sessions ▀
Command Line Interface Reference, StarOS Release 17 ▄
5679
threshold per-service-sgsn-sessions
Configures alarm or alert thresholds for the number of 3G-attached subscribers per SGSN service in the system.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
threshold per-service-sgsn-sessions high_thresh [ clear low_thresh ]
high_thresh
Default: 0
Specifies the high threshold number of 3G-attached subscribers for any one SGSN service. This number must
be met or exceeded within the polling interval to generate an alert or alarm.
Specifies the high threshold number of 3G-attached subscribers for any one SGSN service. This number must
be met or exceeded within the polling interval to generate an alert or alarm.
high_thresh
is an integer from 0 through 2000000. A value of 0 disables the threshold.
clear
low_thresh
Default: 0
Specifies the low threshold number of 3G-attached subscribers for any one SGSN service. This number must
be met or exceeded to maintain a previously generated alarm condition. If the number of subscribers falls
beneath the low threshold within the polling interval, a clear alarm will be generated.
Specifies the low threshold number of 3G-attached subscribers for any one SGSN service. This number must
be met or exceeded to maintain a previously generated alarm condition. If the number of subscribers falls
beneath the low threshold within the polling interval, a clear alarm will be generated.
low_thresh
is an integer from 0 through 2000000. A value of 0 disables the threshold.
Important:
This value is ignored for the Alert model. In addition, if this value is not configured for the Alarm
model, the system assumes it is identical to the high threshold.
Usage
Monitor and set alarms or alerts when the number of 3G-attached subscribers for any one SGSN service in
the system is equal to or greater than the set limit.
Alerts or alarms are triggered for PDP contexts based on the following rules:
the system is equal to or greater than the set limit.
Alerts or alarms are triggered for PDP contexts based on the following rules:
Enter condition: Actual number of 3G-attached subscribers for any single SGSN service is greater
than or equal to the high threshold.
Clear condition: Actual number of 3G-attached subscribers for any single SGSN service is less than
the low threshold.
If a trigger condition occurs within the polling interval, the alert or alarm will not be generated until the end
of the polling interval.
of the polling interval.