для Cisco Cisco Packet Data Gateway (PDG)
GGSN Service Configuration Mode Commands
▀ policy
▄ Command Line Interface Reference, StarOS Release 17
5214
policy
Specifies the reject code to be used in the “Create PDP Context” response message when a RADIUS server timeouts.
Product
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > GGSN Service Configuration
configure > context context_name > ggsn-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ggsn-service)#
Syntax
policy { accounting-server-timeout use-reject-code { system-failure | no-resources } |
authentication-server-timeout use-reject-code { system-failure | user-authentication-
failure } }
authentication-server-timeout use-reject-code { system-failure | user-authentication-
failure } }
default policy { authentication-server-timeout | accounting-server-timeout }
default
Restores the specified parameter to its default setting.
accounting-server-timeout use-reject-code { system-failure | no-resources }
Default:
no-resources
Specifies the reject code used by the GGSN if communication with an accounting server times out. The
possible reject codes are:
possible reject codes are:
system-failure (204 (CCH))
no-resources (199 (C7H))
authentication-server-timeout use-reject-code {system-failure | user-
authentication-failure }
authentication-failure }
Default: user-authentication-failure
Specifies the reject code used by the GGSN if communication with an authentication server times out. The
possible reject codes are:
Specifies the reject code used by the GGSN if communication with an authentication server times out. The
possible reject codes are:
system-failure (204 (CCH))
user-authentication-failure (209 (D1H))
Usage
This command is used to configure the cause code used by the GGSN if communication with either a
RADIUS authentication or accounting server times out.
When this parameter is used in conjunction with Radius accounting servers, the response is only set if a flag
is configured in the APN Delay GTP Response, only after getting a response to the Accounting Start.
RADIUS authentication or accounting server times out.
When this parameter is used in conjunction with Radius accounting servers, the response is only set if a flag
is configured in the APN Delay GTP Response, only after getting a response to the Accounting Start.