для Cisco Cisco Packet Data Gateway (PDG)
MME Service Configuration Mode Commands
▀ policy network
▄ Command Line Interface Reference, StarOS Release 17
7282
policy network
Configures the MME to indicate to the P-GW that all peer SGSNs support dual-addressing for bearers and,
subsequently, dual-addressing must be supported for all IPv4 and IPv6 PDNs. Dual-addressing on SGSNs is based on
the UE’s capability to support inter-RAT roaming.
subsequently, dual-addressing must be supported for all IPv4 and IPv6 PDNs. Dual-addressing on SGSNs is based on
the UE’s capability to support inter-RAT roaming.
Product
MME
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > MME Service
configure > context context_name > mme-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-mme-service)#
Syntax
[ default | no ] policy network dual-addressing-supported
default
Returns the command to its default setting of disabled.
no
Removes the ability to send dual-addressing support messaging from the MME to the P-GW.
dual-addressing-supported
Specifies that the MME shall indicate to the P-GW that dual-addressing is supported.
Usage
Use this command to configure the MME to send messaging to the P-GW that indicate that all peer SGSNs
support dual-addressing for bearers and, subsequently, dual-addressing must be supported for all IPv4 and
IPv6 PDNs.
support dual-addressing for bearers and, subsequently, dual-addressing must be supported for all IPv4 and
IPv6 PDNs.
Important:
This command can be used for Pre-release 8 and Release 8 SGSNs.