для Cisco Cisco Packet Data Gateway (PDG)
ACS Rulebase Configuration Mode Commands
▀ edr voip-call-end
▄ Command Line Interface Reference, StarOS Release 17
682
edr voip-call-end
This command enables/disables generation of EDRs on the completion of Voice over IP (VoIP) calls. This command is
no longer supported for ADC in 14.0 and later releases.
no longer supported for ADC in 14.0 and later releases.
Product
ACS
ADC
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-rule-base)#
Syntax
In StarOS 12.2 and later releases:
edr voip-call-end { charging-edr charging_edr_format_name | edr-format edr_format_name |
reporting-edr reporting_edr_format_name } +
reporting-edr reporting_edr_format_name } +
{ default | no } edr voip-call-end
In StarOS 12.1 and earlier releases:
edr voip-call-end edr-format edr_format_name
{ default | no } edr voip-call-end
default
Configures this command with its default setting.
Default: Disabled; same as
Default: Disabled; same as
no edr voip-call-end
no
If previously configured, deletes the edr voip-call-end configuration from the current rulebase.
edr-format edr_format_name
Important:
This option is available only in 12.1 and earlier releases. In 12.2 and later releases, it has been
deprecated and is replaced by the
charging-edr
option.
Specifies to generate an EDR when a VoIP call ends.
edr_format_name
must be the name of an EDR format, and must be an alphanumeric string of 1 through 63
characters.