для Cisco Cisco Tunnel Terminating Gateway (TTG)
Channelized Port Configuration Mode Commands
▀ path
▄ Command Line Interface Reference, StarOS Release 17
2184
option for either E1 or DS1:
unframed
mapping-mode
bit-sync
byte-sync
timeslots
timeslots
Defines up to 8 timeslot groupings for multiple fractional DS1/E1 channels. Each slot is 2.048/32 Mbytes.
Slots 0 and 16 are reserved for synchronization and alarms. Slots 1-15 and 17-31 are used for data. Timeslots
must be unique -- a timeslot can not be used in more than one grouping.
Slots 0 and 16 are reserved for synchronization and alarms. Slots 1-15 and 17-31 are used for data. Timeslots
must be unique -- a timeslot can not be used in more than one grouping.
timeslots:
Must be an integer from 1 to 31. Timeslot groups are separated by spaces and can consist of a
single slot and/or a range indicated with a hyphen. Example: 3,7-10 is a single fractional group. NOTE there
is no space after the comma. Timeslots must be unique -- a timeslot can not be used in more than one
grouping.
is no space after the comma. Timeslots must be unique -- a timeslot can not be used in more than one
grouping.
frame-relay
Enables definition of a Frame Relay connection with the
frame-relay
command.
Important:
For release 8.1 and higher, this feature has been moved to the
frame-relay
command.
intf-type intf_type
Selecting the interface type specifies signaling parameters for the DLCI, options include:
dce
: Selects data circuit-terminating equipment -type signaling.
dte
: Selects data terminal equipment -type signaling.
nni
: Selects the network-to-network interface
Default: DTE for Release 8.0
Default: DCE for Release 8.1
Default: DCE for Release 8.1
Important:
For release 8.1 and higher, this feature has been moved to the
frame-relay
command.
lmi_type
lmi_type
Default:
none
.
Line management type options include:
ansi
- ANSI ANNEXED LMI, may include option:
cisco
- Cisco/Gang Of Four LMI
none
- LMI Disabled
q933a
- Q.933A LMI
Any of the above LMI types can take one or more additional options
n391 value
- Number of keep exchanges before requesting a full status message. Default is 6.
value
must be an integer from 1 to 255.
n392 value
- Error Threshold value. Default is 2.
value
must be an integer from 1 to 10.