для Cisco Cisco Packet Data Gateway (PDG)
APN Configuration Mode Commands
▀ pdp-type
▄ Command Line Interface Reference, StarOS Release 16
1392
Usage
IP PDP context types are those in which the MS is communicating with a PDN such as the Internet or an
intranet using IP. PPP PDP contexts are those in which PPP or PPP Network Control Protocol (NCP) frames
from the MS are either terminated at, or forwarded by the GGSN.
If a session specifies a PDP type that is not supported by the APN, the system rejects the session with a cause
code of 220 (DCH, Unknown PDP address or PDP type).
intranet using IP. PPP PDP contexts are those in which PPP or PPP Network Control Protocol (NCP) frames
from the MS are either terminated at, or forwarded by the GGSN.
If a session specifies a PDP type that is not supported by the APN, the system rejects the session with a cause
code of 220 (DCH, Unknown PDP address or PDP type).
Caution:
For the IPv6 calls to work, the destination context must have at least one IPv6 interface configured.
Example
The following command configures the APN to support PPP context types:
pdp-type ppp