для Cisco Cisco Packet Data Gateway (PDG)
APN Profile Configuration Mode
▀ location-reporting
▄ Command Line Interface Reference, StarOS Release 16
1480
location-reporting
Configure location change reporting via ULI IE per APN for an S4-SGSN.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > APN Profile Configuration
configure > apn-profile profile_name
Entering the above command sequence results in the following prompt:
[local]host_name(apn-profile-profile_name)#
Syntax
location-reporting access-type { gprs | umts }
remove location-reporting access-type { gprs | umts }
remove
Disables the location change reporting definition in the APN profile configuration.
access-type { gprs | umts }
Allows the operator to select location change reporting for the 2G and / or the 3G subscribers. Both access
types can be identified in a single command or the command can be issued twice. Either way, two separate
entries are created, one for each access type
types can be identified in a single command or the command can be issued twice. Either way, two separate
entries are created, one for each access type
Usage
As with all APN profiles, to enable location change reporting, this APN profile must be associated with a call
control profile.
Location change reporting for a Gn-SGSN is enabled with the
control profile.
Location change reporting for a Gn-SGSN is enabled with the
location reporting
command in the Call
Control Profile configuration mode. That command can be used to configure the location change reporting
function for the S4-SGSN, however that configuration would be over-ridden by an APN profile
configuration. As well, using this APN profile
function for the S4-SGSN, however that configuration would be over-ridden by an APN profile
configuration. As well, using this APN profile
location reporting
command gives the operator greater
control to apply location change reporting per APN.
Example
Enable location change reporting for 2G subscribers:
location-reporting access-type gprs