для Cisco Cisco Packet Data Gateway (PDG)
Context Configuration Mode Commands E-H
▀ hss-peer-service
▄ Command Line Interface Reference, StarOS Release 16
2434
hss-peer-service
Creates a Home Subscriber Service (HSS) peer service or configures an existing HSS peer service and enters the HSS
Peer Service Configuration Mode.
Peer Service Configuration Mode.
Product
MME
SGSN
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx)#
Syntax
hss-peer-service service_name [ -noconfirm ]
no hss-peer-service service_name
no
Removes the specified HSS peer service from the context.
service_name
Specifies the name of the HSS peer service. If
service_name
does not refer to an existing service, a new
service is created if resources allow.
service_name
is an alphanumeric string of 1 through 63 characters.
Important:
Service names must be unique across all contexts within a chassis.
-noconfirm
Executes the command without any additional prompt and confirmation from the user.
Usage
Enter the HSS Peer Service Configuration Mode for an existing service or for a newly defined service. This
command is also used to remove an existing service.
A maximum of 256 services (regardless of type) can be configured per system.
command is also used to remove an existing service.
A maximum of 256 services (regardless of type) can be configured per system.
Caution:
Large numbers of services greatly increase the complexity of management and may impact overall
system performance (for example, resulting from such things as system handoffs). Therefore, it is recommended that a
large number of services only be configured if your application absolutely requires it. Please contact your local service
representative for more information.
large number of services only be configured if your application absolutely requires it. Please contact your local service
representative for more information.