для Cisco Cisco Packet Data Gateway (PDG)
Ethernet Interface Configuration Mode Commands
▀ crypto-map
▄ Command Line Interface Reference, StarOS Release 16
3598
crypto-map
Applies the specified IPSec crypto-map to this interface.
Product
PDSN
HA
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Ethernet Interface Configuration
configure > context context_name > interface interface_name broadcast
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-if-eth)#
Syntax
crypto-map map_name [ secondary-address sec_ip_addr ]
no
Deletes the application of the crypto map on this interface.
map_name
Specifies the name of the crypto map being applied as an alphanumeric string of 1 through 127 characters that
is case sensitive.
is case sensitive.
secondary-address
sec_ip_addr
Applies the crypto map to the secondary address for this interface.
sec_ip_addr
must be specified using the
IPv4 dotted-decimal or IPv6 colon-separated-hexadecimal notation.
Usage
In order for ISAKMP and/or manual crypto maps to work, they must be applied to a specific interface using
this command. Dynamic crypto maps should not be applied to interfaces.
The crypto map must be configured in the same context as the interface.
this command. Dynamic crypto maps should not be applied to interfaces.
The crypto map must be configured in the same context as the interface.
Example
To apply the IPSec crypto map named cmap1 to this interface, use the following command:
crypto-map cmap1