для Cisco Cisco Packet Data Gateway (PDG)
Traffic Policy-Map Configuration Mode Commands
▀ accounting trigger
▄ Command Line Interface Reference, StarOS Release 16
8676
If disabled, the messages are suppressed during the handoffs. The current accounting session continues and
no Stop or Start messages are generated during the intra-service handoff.
no Stop or Start messages are generated during the intra-service handoff.
Usage
Use this command to configure an accounting trigger policy map (ATPM) to selectively start and terminate
accounting sessions based on the categorization of traffic as being interesting or non-interesting. This
command supports the QChat Billing Suppression feature.
Interesting traffic is identified as traffic that does not match any of the other Accounting Policy Maps (APMs)
configured for accounting suppression. See the
accounting sessions based on the categorization of traffic as being interesting or non-interesting. This
command supports the QChat Billing Suppression feature.
Interesting traffic is identified as traffic that does not match any of the other Accounting Policy Maps (APMs)
configured for accounting suppression. See the
accounting suppress
command.
An ATPM is similar to an APM, but without the class map rules. The ATPM is configured as of type
accounting using the
accounting using the
type accounting
command.
Optionally, timeout can be triggered when there is no data traffic for the interim accounting timeout interval
using the
using the
accounting trigger inactivity-timeout stop
command. On timeout, the accounting
session is terminated and an Accounting Stop message is sent. A new accounting session is created if
interesting traffic resumes.
In the ATPM, the trigger to start accounting for interesting traffic is configured using the
interesting traffic resumes.
In the ATPM, the trigger to start accounting for interesting traffic is configured using the
accounting
trigger interesting-traffic
command. Accounting Start is triggered on arrival of interesting traffic,
or change in airlink parameters conveyed through active-start airlink record. If an active-start record was
included in the initial connection setup, Accounting Start is not triggered. But if the active-start comes
separately and is the first one for the session, it is treated as airlink change and an Accounting Start is sent.
The ATPM should have the lowest precedence among the APMs.
As the airlink events are generated on the ingress side, the ATPM must be included in a policy group that is
applied to the ingress direction in the subscriber profile. The configuration is applicable only for standard
trigger policy and session based accounting mode.
included in the initial connection setup, Accounting Start is not triggered. But if the active-start comes
separately and is the first one for the session, it is treated as airlink change and an Accounting Start is sent.
The ATPM should have the lowest precedence among the APMs.
As the airlink events are generated on the ingress side, the ATPM must be included in a policy group that is
applied to the ingress direction in the subscriber profile. The configuration is applicable only for standard
trigger policy and session based accounting mode.
Example
The following command sets the trigger to generate accounting start message upon arrival of interesting
traffic:
traffic:
accounting trigger interesting-traffic