для Cisco Cisco Tunnel Terminating Gateway (TTG)
Context Configuration Mode Commands I-M
▀ ims-auth-service
▄ Command Line Interface Reference, StarOS Release 16
2446
Usage
Use this command to create/configure/delete an IMS authorization service for Gx interface support in the
current context.
Entering this command results in the following prompt:
current context.
Entering this command results in the following prompt:
[context_name]hostname(config-imsa-service)
IMS authorization Service Configuration commands are described in the IMS Authorization Service
Configuration Mode Commands chapter.
Configuration Mode Commands chapter.
Important:
Whenever a new ims-auth-serv is configured using an endpoint that is used by another ims-auth-serv,
then the diabase callbacks are overwritten with values of the new IMSA service. This is a limitation on the system to
register only one application per endpoint. So, multiple IMSA services registering with same endpoint may not work
properly. If such scenario occurs, configure a different endpoint name for the IMSA service being used and then remove
and re-configure the IMSA service used.
register only one application per endpoint. So, multiple IMSA services registering with same endpoint may not work
properly. If such scenario occurs, configure a different endpoint name for the IMSA service being used and then remove
and re-configure the IMSA service used.
Example
The following command configures an IMS authorization service named
ims_interface1
within the
current context:
ims-auth-service ims_interface1