для Cisco Cisco Tunnel Terminating Gateway (TTG)
GPRS Service Configuration Mode Commands
▀ gmm
▄ Command Line Interface Reference, StarOS Release 16
5890
99 - Information element non-existent or not implemented
100 - Conditional IE error
101 - Message not compatible with the protocol state
111 - Protocol error, unspecified
ciph-gmm-msg-from-unknown-ms { detach | ignore }
Configures how the SGSN will behave when it receives a ciphered GMM message from an unknown MS.
detach
- Instructs the SGSN to send a Detach message to the MS.
ignore
- Instructs the SGSN to send an Ignore (drop) message to the MS.
Default:
ignore
implicit-detach-timeout secs
Specifies the implicit detach timer (IDT) value for the 2G ISR implicit detach procedure on the network side
(see ISR -- Idle Mode Signaling Reduction on the S4-SGSN feature chapter in the SGSN Administration
Guide for additional timer usage details).
The IDT is configurable from release 15.0 onwards and it is only applicable to 2G ISR activated calls. If ISR
is not activated on a 2G call then the subscriber is detached soon after expiry of the mobile reachability timer
(MNR) timer.
(see ISR -- Idle Mode Signaling Reduction on the S4-SGSN feature chapter in the SGSN Administration
Guide for additional timer usage details).
The IDT is configurable from release 15.0 onwards and it is only applicable to 2G ISR activated calls. If ISR
is not activated on a 2G call then the subscriber is detached soon after expiry of the mobile reachability timer
(MNR) timer.
secs
must be an integer from 240 to 86400 and the default value is 3600.
mobile-reachable-timeout mins
Default: 58 minutes
Specifies the timeout value for the mobile reachability timer (MNR). This timer is used with the IDT timer
described above.
Specifies the timeout value for the mobile reachability timer (MNR). This timer is used with the IDT timer
described above.
mins
must be an integer from 4 to 1440.
negotiate-T3314-timeout secs
Set the number of seconds for the T3314-timeout ready timer value. Value sent out from SGSN so MS can
negotiate ready timer.
negotiate ready timer.
secs
must be an integer from 0 to 11160. Default is 44 seconds.
If the MS does not send the ready timer in the Attach/RAU request, then the SGSN sends this T3314-
timeout (ready timer) value.
If the MS sends the requested value of the ready timer in the Attach/RAU Request, and if the requested
value is less than or equal to the value of the negotiate-T3314-timeout timer, then the SGSN sends
Att/RAU Accept with the requested T3314 value.
Att/RAU Accept with the requested T3314 value.
If the MS sends the requested value of the ready timer in the Attach/RAU Request, and if the requested
value is greater than the value of the negotiate-T3314-timeout timer, then the SGSN sends Att/RAU
Accept with the negotiate-T3314-timeout value.
Accept with the negotiate-T3314-timeout value.
Important:
This is the only GMM timer that can be disabled by entering
no
at the beginning of the command
syntax:
no gmm negotiate-t3314-timeout
By disabling negotiation of the T3314-timeout value, if the MS sends
the requested value of the ready timer in the Att/RAU Request, then the SGSN sends the T3314-timeout value in the
Att/RAU Accept.
Att/RAU Accept.