для Cisco Cisco Tunnel Terminating Gateway (TTG)
QCI - QoS Mapping Configuration Mode Commands
qci ▀
Command Line Interface Reference, StarOS Release 16 ▄
7923
max-packet-delay
max-packet-delay-value
max-error-rate
max-error-rate
max-packet-delay num
: Specifies the maximum packet delay (in milliseconds) that can be applied to the
data with the QCI.
max-packet-delay-value
must be an integer from 10 through 1000.
max-error-rate
num
: Specifies the maximum error loss rate of non-congestion related packet loss.
max-error-rate
must be an integer from 1 through 6, specifying 10-1 through 10-6.
Important:
Defaults for standards-based QCI values are defined in 3GPP Specification TS 23.203 “Policy and
charging control architecture”.
non-gbr
Specifies that this QCI type is non-Guaranteed Bit Rate (non-GBR).
traffic-policing interval interval
Specifies the traffic policing interval associated with the this QCI.
interval
must be an integer from 1 through 100.
uplink
Configures parameters for uplink traffic.
user-datagram dscp-marking dscp-marking-value
user-datagram dscp-marking
: Specifies that the IP DSCP marking is to be defined by this keyword.
dscp-marking-value
is expressed as a hexadecimal number from 0x00 through 0x3F.
Usage
Use this command to create and map QCI values to enforceable QoS parameters.
Important:
Non-standard QCI values are not supported.
Example
The following command creates a QCI value of
8
and defines the uplink encapsulation header as using the
DSCP marking from the encapsulated UDP header:
qci 8 uplink encaps-header copy-inner