для Cisco Cisco Packet Data Gateway (PDG)
GGSN Changes in Release 17
▀ GGSN Enhancements for 17.3
▄ Release Change Reference, StarOS Release 17
172
default: Configures the default control packet retransmission timeout in GTP.
retransmit_time:
Specifies the GTP control packet retransmission timeout in milliseconds. Must be an
integer from 1000 to 20000, with increments of 100.
Default: 5000
retransmission-timeout-ms
This new CLI command introduces 100 millisecond (ms) timer granularity for the T3 timer.
The range for the T3 value was 1 to 20 seconds, with a default value of 5 seconds. The new range is 1000 to 20000 ms,
with increments of 100 ms.
with increments of 100 ms.
configure
peer-profile service-type [ ggsn-access | pgw-access | sgw-access | sgw-network ] name
peer_profile_name
peer_profile_name
gtpc-service service_name
gtpc retransmission-timeout-ms retransmit_time
default gtpc retransmission-timeout-ms
end
Notes:
default: Configures the default control packet retransmission timeout in GTP.
retransmit_time:
Specifies the GTP control packet retransmission timeout in milliseconds. Must be an
integer from 1000 to 20000, with increments of 100.
Default: 5000
CSCus80582 - 3G call - All packets are dropped due to APN AMBR limiting
Feature Changes
Change in ‘apn-ambr rate-limit direction’ CLI Command
In 17.3 release and onward, the CLI mentioned in Command Changes section below has been modified. The option
bytes
has been deprecated and can no longer be used. However, this command option is available in earlier releases.
Previous Behavior: The command option
bytes
was available in the CLI command
apn-ambr rate-limit
direction
.
New Behavior: The command option
bytes
has been deprecated and is no longer available in the CLI command
apn-
ambr rate-limit direction
.
Command Changes
apn-ambr rate-limit direction