для Cisco Cisco Packet Data Gateway (PDG)
P-GW Changes in Release 17
▀ P-GW Enhancements for 17.0
▄ Release Change Reference, StarOS Release 17
400
Previous Behavior: For P-GW, if radius returned ip pool for ip address alloc method as no-dynamic, then ip address
allocation was not successful.
allocation was not successful.
New Behavior: For P-GW, if radius returns ip pool for ip address alloc method as no-dynamic, then ip address
allocation will be successful.
allocation will be successful.
Customer Impact: The customer will be able to use no-dynamic ip alloc method for radius returned ip pool.
CSCuo11336 - Update bearer Request not triggered on FUA action from Gy
Feature Changes
Update Bearer Request Triggered on FUA Action from Gy
The UBR should go when FUA triggered from Gy.
Previous Behavior: If Gy sent the same PCO value twice, UBR was initiated again for the same PCO.
New Behavior: Now, UBR will not be initiated in above scenario because previous PCO action value is stored before
modifying the CLP PCO action value.
modifying the CLP PCO action value.
CSCuo38762 - congestion-control threshold related CLI not visible in show
config
Feature Changes
Congestion-control Threshold related CLI Not Visible in Show Config
Updated the congestion-control command in the Command Line Interface Reference.
CSCuo90006 - Formulation of P-CSCF Address Output as part of show sub full
all
Feature Changes
Formulation of P-CSCF Address Output as Part of show subscribers full all
Simplified the P-CSCF Address Output as part of
show subscribers full all
command output. The P-CSCF
discovery mode specific information is SR/GR recovered.
Previous Behavior: Previously, the P-CSCF Address output displayed the P-CSCF Address information separately for
S6b based FQDN and for Radius or configured scenarios. It also restricted the S6b mode to only display the IPv6
Address Information. IPv4 information was not being displayed. In addition, the earlier output did not support
persistence across ICSR/Session Recovery for all the discovery modes.
S6b based FQDN and for Radius or configured scenarios. It also restricted the S6b mode to only display the IPv6
Address Information. IPv4 information was not being displayed. In addition, the earlier output did not support
persistence across ICSR/Session Recovery for all the discovery modes.
New Behavior: In the new output, a “Discovery Mode” field specifies the method of discovery followed by the actual
P-CSCF Address information. Also, the new output displays both IPv4 and IPv6 address information as per
applicability. The new output remains persistent across ICSR/Session Recovery for all P-CSCF discovery modes.
P-CSCF Address information. Also, the new output displays both IPv4 and IPv6 address information as per
applicability. The new output remains persistent across ICSR/Session Recovery for all P-CSCF discovery modes.