для Cisco Cisco Packet Data Gateway (PDG)
ECS Changes in Release 16
▀ ECS Enhancements for 16.2
▄ Release Change Reference, StarOS Release 16
110
ECS Enhancements for 16.2
This section identifies all of the ECS enhancements included in this release:
Feature Changes - new or modified features or behavior changes. For details, refer to the ECS Administration Guide
for this release.
for this release.
Command Changes - changes to any of the CLI command syntax. For details, refer to the Command Line Interface
Reference for this release.
Reference for this release.
Performance Indicator Changes - new, modified, and deprecated bulk statistics, disconnect reasons, counters and/or
fields in new or modified schema and/or show command output. For details, refer to the Statistics and Counters
Reference for this release.
fields in new or modified schema and/or show command output. For details, refer to the Statistics and Counters
Reference for this release.
CSCup08420, CSCup49998 - PGW (Gp) rejecting dynamic rule with Unknown
Bearer ID cause
Applicable Products: GGSN, P-GW
Feature Changes
Handling of Rule Modification in UE Only Mode for EPS IP-CAN Bearer
Previous Behavior: Earlier rule binding was getting rejected.
New Behavior: Now, the binding of PCEF rules will be successful when BCM mode is set to UE-only for EPS IP-
CAN bearer without “bearer-ID” in the PCRF messages such as RAR or CCA-U.
CAN bearer without “bearer-ID” in the PCRF messages such as RAR or CCA-U.
Customer Impact: Rule binding in the 3G to 4G handover scenario will be successful in UE-only mode and any filter
(and related info) changes because of this modification/installation/removal will not be notified to UE as updates in UE
only mode cannot be sent to UE.
(and related info) changes because of this modification/installation/removal will not be notified to UE as updates in UE
only mode cannot be sent to UE.
These rules are only considered for charging and the expectation is that the same rules are again modified in 4G (if
handover is done) so that the filters (and related info) can be notified to UE.
handover is done) so that the filters (and related info) can be notified to UE.
CSCup67356 - Rule failure counters not incremented
Applicable Products: GGSN, HA, HSGW, IPSG, PDSN, P-GW, SAEGW
Feature Changes
Counter for ACS Reject Reason in No Active Rule Condition
Previous Behavior: The subscriber call was rejected when there was no active rule in the rulebase. In this scenario,
there was no counter to indicate the corresponding reason for the call rejection through the CLI command “
there was no counter to indicate the corresponding reason for the call rejection through the CLI command “
show
active-charging service statistics
”.
New Behavior: Now, the “
show active-charging service statistics
” CLI command will indicate the total
number of ACS calls rejected due to no active rule.