для Cisco Cisco Packet Data Gateway (PDG)
SAEGW Changes in Release 16
▀ SAEGW Enhancements for 16.0
▄ Release Change Reference, StarOS Release 16
402
Customer Impact:
Operators now can configure a bearer inactivity timeout for GBR and non-GBR bearers for
more efficient use of system resources.
Command Changes
timeout bearer-inactivity
The new command
timeout bearer-inactivity
supports a bearer inactivity timeout for GBR and non-GBR S-GW
bearer type sessions.
configure
apn-profile apn_profile_name
timeout bearer-inactivity [ gbr | non-gbr ] dur_seconds volume-threshold { total
bytes | uplink bytes | downlink bytes} | exclude-default-bearer
bytes | uplink bytes | downlink bytes} | exclude-default-bearer
remove timeout bearer-inacativity [ gbr | non-gbr ]
end
Notes:
timeout
: Specifies that a session time out value will be configured for this APN profile.
bearer-inactivity
: Specifies that the system will check for low activity for a bearer.
gbr
: Specifies that the system will check for low activity on a GBR bearer.
non-gbr
: Specifies that the system will check for low activity on a non-GBR bearer.
dur_seconds
: Specifies the timeout for the
gbr
or
non-bgr
bearer inactivity timer in seconds. Valid entries
are from 900 to 2592000 seconds (15 minutes to 720 hours).
volume-threshold
: Specifies that a threshold value of the data traffic for a bearer will be used for the
inactivity timeout value.
total
: Specifies that the total of both uplink and downlink data will be used as a volume threshold.
bytes
must
be a value from 1 to 4294967295.
uplink
: Specifies that an uplink data volume threshold will be used.
bytes
must be a value from 1 to
4294967295.
downlink
: Specifies that a downlink data volume threshold will be used.
bytes
must be a value from 1 to
4294967295.
exclude-default-bearer
: Specifies that inactivity handling for the default bearer will be excluded.
Performance Indicator Changes
show apn-profile full name
This command has been enhanced to list bearer inactivity timeout settings, if configured.
Bearer inactivity timeout:
Exclude default bearer :Yes/No